Item No.: CH131266-AL

Hand Chamfering Tools

Features:

* Adjustable wind knob

* Swivel Rear exhaust

* Lightweight / Mini type, easy to operate

* Safety trigger

Specification:

* Chamfering capacity: C0.1 – C2mm.

* Size: 120mmL x 65mm Height

* Air exhaust: Rear

* Sound level: 85dB

* Free speed: 30,000rpm

* Air consumption: 2.3cfm

* Overall length: 120mm

* Weight: 0.42kg

* Air inlet: 1/4”

* Air hose: 3/8”

Hand Chamfering Tool - How to use:

Hold the tool firmly, release the lock lever, and depress the throttle lever to start the tool.

Place the Guide Plate on the workpiece, and slowly pull the tool towards you or push it forward to introduce the index-able inserts to the material.

While chamfering the inner hole holding the Guide Bearing against the workpiece, move the tool in a clockwise motion. (Fig.1)

While chamfering the outer diameter holding the Guide Bearing against the workpiece, move the tool in a counterclockwise motion. (Fig.2)

How to replace indexable inserts:

1. Loosen two Hex Socket Set Screws on the Guide Plate with the Hex Socket Screw Key. (Fig.3)
2. Unscrew the Guide Plate and loosen the Indexable Insert Set Screw with the Spanner T-6. (Fig.4)
3. Install the new Indexable Insert (or the Indexable Insert rotated to a fresh edge) making sure it is in the correct direction and tighten it with the Indexable Insert Set Screw.
4. Also replace the other Indexable Insert in order of the above (2) and (3).
5. Install the Guide Plate, adjust the Indexable Insert for the desired chamfering amount, and tighten the two Hex Socket Set Screws.